Roll Size: 6mm to 1000mm in 50 Metre Lengths
Adhesive: Acrylic Solvent
Description: A transfer tape with an LSE modified solvent acrylic adhesive reinforced with fibreglass. Developed for use as a general mounting tape, particularly where high adhesion to low surface energy substrates is required (Polypropylene, PE, Powder Coatings and UV coatings).
Application: Permanent mounting of nameplates, trim, decorative moulds. Particularly for the joining, mounting and splicing of low energy surfaces. Used as a foam lamination tape in automotive and construction applications. For mounting of materials to rigid surfaces in the curtain and blind trade
|180º Peel adhesion:|
|Painted Steel:||20 Mins 8.5 N/cm|
24 Hour 11.0 N/cm
|ABS::||20 Mins 9.0 N/cm|
24 Hours 9.5 N/cm
|Polypropylene:||20 Mins 9.0 N/cm|
24 Hours 10.0 N/cm
|Service Temperature:||-40°C to 90°C|
|Short Term Temperature:||150°C|
Surface Preparation: The surface on which the tape is to be used must be clean, dry and free from grease and dust. Remember that pressure sensitive adhesive must be applied with the maximum possible pressure in order to achieve maximum adhesion levels. The recommended application temperature is between 18ºC and 25ºC.
Storage: Tapes stored below the minimum application temperature will require warming up to that level before use. Up to 24 hours may be required for this to take place.
Note: The above figures represent average values. Actual figures can vary. The selection and application of a tape is the responsibility of the buyer. Tape should be stored at room temperature and should not be exposed to sunlight. We reserve the right to make changes without notice to our products and specifications.