PE Protection Tape by Tenacious Tapes. Adhesive tape comparable to Tesa 4170, Stylus 2923 PE Tape or 135 Polyethylene Protection Tape. Order online from exclusive approved supplier Wayout Evacuation Systems.
Roll Size: 24mm to 1350mm in 50 Metre Lengths
Adhesive: Acrylic Emulsion
– Easy to unwind and tear
– Clean peel from most surfaces
– UV resistant
– Frost resistant
– Good low temperature resistance
– Environmentally responsible choice
– Protection, masking and joining of sheeting to delicate surfaces during renovation
– Protection of finished goods in production or during transit
– Protection of yacht in transit
– Masking off during sign writing and painting of buses
|Breaking Load:||15 N/cm|
|Elongation at Break:||200%|
|Adhesion to Steel:||1.3 N/cm|
|Service Temperature:||40ºC to 60ºC|
|Application Temperature:||10ºC to 45ºC|
NOTE: The performance of AT6102 is impaired if used on anodised surfaces which are not completely sealed. Advance Tapes recommend that AT6102 is tested on aluminium or stainless steel surfaces to assess its suitability
Surface Preparation: The surface on which the tape is to be used must be clean, dry and free from grease and dust. Remember that pressure sensitive adhesive must be applied with the maximum possible pressure in order to achieve maximum adhesion levels. The recommended application temperature is between 15ºC and 30ºC.
Storage: Tapes stored below the minimum application temperature will require warming up to that level before use. Up to 24 hours may be required for this to take place.
The above figures represent average values. Actual figures can vary. The selection and
application of a tape is the responsibility of the buyer. Tape should be stored at room
temperature and should not be exposed to sunlight. We reserve the right to make changes
without notice to our products and specifications.