Roll Size: Widths 6mm to 450mm in 9 metre lengths
Adhesive: Self Amalgamating
Description: AT85 is based on non-adhesive polyethylene. It is tough and very elastic with high water and ozone resistance and can be applied easily. It has excellent resistance to a wide range of chemicals including alkalis, hydraulic fluids and vegetable oils and has a very high dielectric strength. AT85 has an easily removed interleave.
Application: Insulating terminations and joints between such materials as butyl rubber, PVC, polyethylene, EPR and oil based rubbers of power cables rated up to 35 kV. Repair and insulation of trailing cables.
|Breaking Load:||12 N/cm|
|Elongation at Break:||600%|
|Electrical Strength:||4000 V/0.1mm|
|Service Temperature:||-95°C to 95°C|
|Application Temperature:||0°C to 40°C|
Surface Preparation: The surface on which the tape is to be used must be clean, dry and free from grease and dust. Remember that pressure sensitive adhesive must be applied with the maximum possible pressure in order to achieve maximum adhesion levels. The recommended application temperature is between 15ºC and 25ºC.
Storage: Tapes stored below the minimum application temperature will require warming up to that level before use. Up to 24 hours may be required for this to take place.
The above figures represent average values. Actual figures can vary. The selection and
application of a tape is the responsibility of the buyer. Tape should be stored at room
temperature and should not be exposed to sunlight. We reserve the right to make changes
without notice to our products and specifications.