UHMW Polyethylene Anti Abrasion Tape by Tenacious Tapes. Adhesive tape comparable to 3M UHMW Film Tape 5423, Permacel GLIDE10 or Nitto 443. Order online from exclusive approved supplier Wayout Evacuation Systems.
Roll Size: 6mm to 610mm in 16.5 Metre Lengths
Adhesive: Solvent Acrylic
Description: A heavy duty Ultra High Molecular Weight PE film coated with a an acrylic pressure sensitive adhesive and supplied on a release liner. A 0.30 mm film of high tack modified acrylic adhesive designed to bond to variety of LSE substrates.
Application: UHMW is used as a permanent anti-abrasion finish and for providing a low coefficient of friction to surfaces to reduce chafe and abrasion. May be used as a permanent protection tape on surfaces. Used on guide rails, door and draw slides and chute linings to provide slip and reduce wear
|Breaking Load:||15 N/cm|
|180° Peel Adhesion (PSTC-3):||6.6 N/cm|
|Static Sheer (PSTC-7):||6.5 cm2/2.5 Kgs, >200 Mins|
|Tensile Strength:||96 N/cm|
|Service Temperature:||-20°C to 105°C|
|Short Term Temperature:||115°C|
Surface Preparation: The surface on which the tape is to be used must be clean, dry and free from grease and dust. Remember that pressure sensitive adhesive must be applied with the maximum possible pressure in order to achieve maximum adhesion levels. The recommended application temperature is between 10ºC and 25ºC.
Storage: Tapes stored below the minimum application temperature will require warming up to that level before use. Up to 24 hours may be required for this to take place.
Note: The above figures represent average values. Actual figures can vary. The selection and
application of a tape is the responsibility of the buyer. Tape should be stored at room
temperature and should not be exposed to sunlight. We reserve the right to make changes
without notice to our products and specifications.